Yuichi Hyperbolic 2" horn A290

Description

Here is a professionally reproduced clone of the Yuichi A-290 FL. Horns was machined on a industrial grade CNC router. Each pair of horns takes approximately 15 hrs to complete, 10 hrs on the cnc router. The cnc shop rate is 0/hr
Here are the specification.
Horn dimension: 22.625" X 13.375" X 9.
Horn Contour: Hyperbolic
Cut-off frequency: 300Hz
Frequency range: 300Hz to 20KHz
Driver: 2 inch. or 5 cm throat, TAD 400x or JBL 2441/5/6 or equivalent
Horns that is available: Dimension are approximately half of those of the 2" horns.
3 pairs- Poplar $ 1400/pair
2 pairs-Cherry $ 1600/pair
1 pair- MDF $ 800/pair
1 horn- Ambrosia Maple $ 500/piece
Also available are 1 inch throat, hyperbolic contour with a 1600 hz cut-off freqency horns.
4 pairs Cherry. 0/pair
5 pairs Poplar. 5/pair
2 pairs Ambrosia Maple. 0/pair
Made in the USA!